PHR PNP Harness for IS300 Fan Kit

Posted on by Dylan

Price: Email us for a quote!

PHR PNP Harness for IS300 Fan Kit

Our PNP Harness for our IS300 Fan Kit. *available here* (http://www.gorillaindustries.com.au/2014/08/phr-is300-fan-kit-for-1993-98-supra-non-polished/)

Simplify the wiring on your dual fan setup. Run you fans on LOW or HIGH. High activates with the Air conditioning as well as on command using the “High input” wire.

Works on any dual fan setup.

We use only the highest grade components and wiring in all of our wire harness products.

INSTALLATION
1. Bolt the ground to the chassis ground located below and to the left of the fuse box.
2. Connect the EB1 connector (8pin) in-line of the factory EB1 connector (located below fuse box).
3. Run fan wires routed along factory wires to the IS300 fan kit and plug in the connectors to the IS300 fans.
4. Connect Positive terminal to positive terminal of the fuse box. Make sure battery is disconnected first.
5. Secure relays using zip ties, or double sided adhesive tape to fuse box or wiring. (you can also use a small screw to secure, but be careful not to damage wiring inside fuse box.

PHR 01010714

PHR PNP Harness for IS300 Fan Kit

This entry was posted in Engine - New, New, Parts, PHR Toyota, Power House Racing. Bookmark the permalink.

Comments are closed.